Fidget Spinners are everywhere - one of the challenges is to get the fastest spinning and longest running Spinner...build a sensor!
An opensource 3D printed aquarium controller with IOT capabilities.
Using PSoC and LinkIt ONE send analog sensor values to Blynk and then, with the power of IFTTT control your smart devices based on the data!
Using Google Assistant and Amazon Alexa, we can control our home's electronics gadgets (up to 240 v). Also with smartphone application.
Monitor your workspace or your home with this simple solution that sends all the data by radio so you can work with them.
This battery charger monitor uses an OLED display & Blynk to show you its charge current, bus voltage, load voltage & elapsed time.
This turns on a bathroom fan automatically when its humid.
Stay informed about soil-measurement by using Particle Photon.
Make an affordable but smart Alarm system for your home, or any of your buildings. It can run up to 2 years just from batteries.
I made remote control car. The motors are controlled by smartphone application Blynk and Pi Zero W with the I2C input motor driver.
Gutters to Gardens is a solar powered rain barrel for remotely or automatically activating a water distribution system for home garden beds.
Protect your home from the flood with this simple device. It will send you the notification when there is some leak in a bathroom or kitchen
A method in which waste management is automated. An innovative system that will help keep the city clean and healthy.
An I2C interface with Blynk.
I wanted to make a robot. However, I could only make a foot because my money ran out.
Control your heating with this simple device that is easy to modify. You can control your sunblinds or boiler for optimal temperature.
A solution to measure noise level and sound pollution in urban areas.
Use a LattePanda and Blynk to make a simple but cool IoT control unit.
This system sends alerts to your smartphone when there is movement in the house, also allows monitoring the temperature of the place.
How easy is to do the link between my Arduino Yun and one mobile using free soft Blynk.
With this project you can play any sound from your SD card on your audio system. Only wire you will need is 3.5mm jack.
This is a simple project for those who want to make a relay module using one BC547 transistor.
With this project, we will be able to water our plant automatically and monitor it from our smartphone.
Turn on a fan automatically with a Particle Photon using temperature sensing and the Blynk app.