Based on sensor data open/close window via actuator and turn on/off fans. App via Blynk platform. Entirely solar powered.

How to make an IoT Based Early Flood Detection & Avoidance how to create an IoT Based Early Flood Detection & Avoidance

How to make Smart Door Receptionist with Smart Lock System Using IoT how to create a Smart Lock System Using IoT

This Smart Water Meter has an inductive proximity sensor connected to an ESP32 is programmed in ARDUINO and uses the BLYNK IoT platform.

Garage Door IOT Monitor and Controller, linked to Home Assistant using MQTT. Also, OTA updates make it so I don't need a ladder for updates.

How to make a smart waste management system using iot, how to create a smart waste management system

How to make a IoT Based Patient Health Monitoring System How to create a human health monitoring system

How to make a smart Air Quality Monitoring System, How to create a smart Air Quality

How to make a smart greenhouse using Arduino and Node MCU for IoT

Control and Monitor your ESP32 Dev Board with the Blynk IoT Cloud. Guide for Blynk 1.0 (legacy) and Blynk 2.0 API uses

How to make a smart animal health monitoring system How to create a smart animal tracking system

Smart step counter shoe using ESP8266, Infrared Sensor and a LiPo battery.

How to make smart safety and health monitoring for construction workers, How to create a smart safety system

Save time by knowing whether the Faculty is in his chamber or not.

Waterman is a device in form of a box which will check the contamination level of water and also the availability of water in the pipeline.

We use an Arduino to build an autonomous "follow me" cooler that connects to a smartphone via Bluetooth and uses GPS to navigate.

Collect environmental factors and culture amount while producing yogurt. Then, run a neural network model via Blynk to predict its texture.

It's smart... It's automatic... it's a humidifier... It's a Charizard!

It's difficult to make communication with ESP-01 module but today I'll show how to do it in the simplest way.

Harsh Weather Monitoring Using Arduino MKR 1300 and Blynk

I wanted to create a device that could spin spools of thread when I pressed a button so I could just cut the thread and continue sewing.

In this easy project we'll connect a temperature and humidity sensor to an Arduino Uno with an Ethernet Shield and we'll use Blynk.

This health band can assist old people in their daily lives, leaving the family stress free!

My aim is to minimize the loss of electricity there is when people forget to switch off their fans or lights, through smart home solution.